- Cable bundler

- Flashlight holder


Tips ( DIY )
Battery charge indicator
- Battery holder
Bicycle pump holder
- Flashlight holders :
   - medium
    - mini 1 , mini 2
    - micro

- Lens cap holder
- Flash bouncer
   - small reflector
   - big reflector/ light box

- New tips, 2014 -

Prototypes :
Bicycle bottle holders



DIY - Smartphone tripod / stand version 3

How to make a small stand / tripod* for smartphones,
- easy to make and simple to use.

Design by Benny Johansson

Smartphone tripod / stand version 3
The phone can be tilted 0-8 degrees on one side and 15 on the other.
Very small and light, fits on a keychain.
How to make it
- a piece of polypropylene (PP) plastic from a DVD-case , minimum 6 x 4 cm
( the DVD case can still be used afterwards )   
- Self vulcanizing rubber tape (also called self-fusing or self amalgamating tape)
alternative: a thin piece of rubber and double adhesive tape would also work
Step 1:
- cut out the plastic piece,
  this material is thick so use a sharp blade and cut multiple times to get through
( slide in a thick piece of cardbord like shown below to protect the outer cover and inlay)
- print out the PDF template and tape it on the plastic piece
- make the holes and make a surface mark through the cutting lines with a sharp knife
Step 2:
Remove the template and cut out the piece as shown below.
Step 3:
Pre-bend the plastic piece a little bit like shown below
Step 4:
- heat bend to a 90 degree angle like shown below
  ( I used a piece of aluminium foil to concentrate heat to the bending area)
- wrap a thin layer of rubber tape as shown below
  ( you could also use a thin piece of rubber and double adhesive tape on the top side )

* Tripod might not be the correct definition but I think it describes the
   function better than "camera support" .

Copyright © Benny Johansson